Motor M2 will start automatically a closing cycle.Press again P1 in the point where you desire to set the leaf
delay in closing.
When the leaf reaches the mechanical stop in closing press once again P1 (Fig. 10).
At this point motor M1 will also start a closing cycle.
When the leaf reaches the mechanical stop in closing press once again P1 (Fig. 11).
Programming is finished.
Check the correct times memorizing giving a start impulse or pressing the button P1. If necessary repeat
the same learning procedure from step 2.
P1
P1
Fig. 10
M2
M1
M2
M1
Fig. 11
PHASE 4
In case of use use with motor reducer without mechanical / hydraulic device for motor torque limitation,
adjust trimmer Rv1 on values which can assure the anti-crushing safety in accordance with the law in force.
If after adjusting the motor torque the working time is not enough (the leaf doesn’t open / close completely),
repeat STEP 2 setting the motor torque value as for the usual use of the automation.
Adjust the slowdown time (if enabled), using trimmer Rv2.
NOTE: assure that, in SAFETY GATE assistance (Encoder), DIP 4 is placed to OFF position.
4
SWING 2
33
WORKING TIMES SELFLEARNING
ON SWING GATE
1) Connect motors cables to terminals No. 9,10,11 of Cn2 terminal board
2) Move to zero TRIMMER Rv2 of leaf delay
3) Place to ON position dip8 (working times adjustment mode using trimmer)
4) Execute working times adjustment as explained in the related paragraph at page 34 of the instructions
manual.
ONE LEAF MODE
(ONLY IN WORKING TIMES ADJUSTMENT MODE USING TRIMMER )
English
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
REV 07 - 05/2009
