WORKING TIMES ADJUSTMENT
USING TRIMMER ON SWING GATE
SWING 2
PHASE 1
Place DIP8 to ON position and press button P1 or START, the gate will execute a complete opening / closing
cycle.
Note:
It is strongly advised against to use this modality in case of swing gates with leaves with different
opening angles and speeds.
1
At this point if the gate doesn’t reach the mechanical stop in opening, increase trimmer Rv4 (rotate
clockwise) and give again a START impulse.
On the contrary, if the gate executes a too long complete opening / closing cycle, decrease trimmer Rv4
(rotate counter clockwise).
Repeat the procedure until the gate will reach the complete and requested opening and closing cycle.
When this mode is on it’s possible to adjust the leaf delays using trimmer Rv2.
NOTE: WHEN THIS MODE IS ON THE USE OF ENCODERS IS DISABLED.
8
1 2 3 4 5 6 7
ON
M2
M1
M2
M1
M2
M1
M2
M1
Rv4
34
English
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
REV 07 - 05/2009
