SWING 2
ON
SETTING OF THE OTHER FUNCTIONS THROUGH DIP-SWITCH
PRE - FLASHING
When this function is activated the flashing lamp begins flashing about 3 seconds before the motor
starts to work, both in closing and opening.
DIP
2
POSITION
ON
SELFTEST PHOTOCELL
When this function is activated a test is executed on the photocells before the gate starts to move. In
order to enable this function the photocells transmitters must be connected to terminals 11 (24V) and
2 (Negative) of connector CN1.
The selftest can be exclusively used with the imput photocell 1.
3
ON
ENCODER MANAGEMENT (only in working times selflearning mode)
When this function is activated, the impulses coming from an encoder placed on the motor or on the
gate are managed, so that any obstacle which interrupts the passage can be detected and the gate
reverses its movement.
If a malfunctioning occurs, the flashing lamp will execute a sequence of 3 flashings.
After every single intervention the gate proceeds at reduced speed until it reaches the positive stop.
NOTE: if no encoder is installed, place DIP to OFF position.
Note: The Encoder sensibility can be adjusted through the PALM or through the pushbuttons
Ptime and Pcode on board of the control unit.
4
ON
SLOWDOWN AND LIMIT SWITCH
When this function is activated motor speed reduces slowly before the gate reaches the limit switch
stop or before the operating time ends.This function is designed in order to get the leaf gently closer
to the mechanical stops, avoiding any noisy clash. The closing speed is fixed, while the slowdown
time can be adjusted using the trimmer Rv2.
5
ON
6
ON
REVERSING STROKE
This function (to be used exclusively on swing gates) is useful to facilitate the electric lock release.
At the start impulse the leaves in closing phase are powered for 1 second approximately, before the
opening cycle starts..
7
DIP
1
2 3 4 5 6 7 8
ON
DIP
ON
WORKING TIMES ADJUSTMENT USING TRIMMER
This DIP when on ON position allows to activate the adjustment of the working times with trimmer,
de-activating the selflearning.
8
ADDITIONAL FUNCTIONS (DIP-SWITCH)
English
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
REV 07 - 05/2009
26
LEAF LOCKING
When this function is activated, at the end of slowdown phase, and when the leaf has reached the
mechanical stop, the motor is supplied at maximum power for 1 second approximately. This
increases the oil pressure in the motor and makes the hydraulic lock more effective.
WARNING: this function must not be activated on a sliding gate since it could cause the over
- running of the limit switches, with following block of the automation.
(Through the PALM it is possible to exclude the PUSHOVER in opening).
