Sea Tel DAC-2202, Installation And Operation Manual

Page: 63 / 115

DAC-2202 Antenna Control Unit Diagnostic M&C Software Installation & Use
7-13
then press ENTER, this will then display “Password
changed.’ as an indication that the command was
accepted.
Type in “[W” to submit changes to memory
Type in “[Z” to reset the CommIF module and take
effect.
Once this command has been entered and saved all
remote access requiring authentication (TCP0/1 if
enabled and the Web page access, will use this new
password.
7.9. Updating Your System Software:
There are four processors each (referred to as the “Target Module” below) in the DAC2202 / DAC2302 Antenna
Control Units that
may require software updates. There is one processor in the Pedestal Control Units, with the
exception of the Series 09 systems which have two processors (one for the PCU Main PCB and one for the 400MHz
Modem PCB), that
may require software updates. The following table is intended to be used as a quick reference to
determine the appropriate software program/files to use during the process of uploading software to your Below Decks
and Above Decks Equipment.
NOTE : Choosing the incorrect Translation Mode or Software Filename may render your
system inoperable, contact the Sea Tel Service Department if your intended Target Module is not listed below or if
you need additional assistance.
ACU
Model
Target Module Software Program /
Translation Mode or
(Ram Loader)
Typical Software Module Filename
Format
(where xx is the latest version number)
DAC2202
ACU Main PCB ProgTerm / DAC2K to ACU DAC-2202_6. xx .S19
Tracking
Receiver PCB ProgTerm / DAC2K to DVB
DVB Receiver
DVB5. xx .S19
L-Band SCPC Receiver SCPC5. xx .S19
COMMIF PCB SHDownload /
C:\...\SHDownload\PDL-
Generic.bin COMMIF_1. xx .bin
P edestal C ontrol
U nit PCB
ProgTerm / DAC2K to PCU xx03/xx06 X03-2. xx .S19
xx04 X04-2 xx K.s19
xx09 X09-PCU-1. xx .S19
xx97(A/B)/00/07(D) Model Specific
Synchro
Converter **Not Flash
Programmable**
Sea Tel Programmer
required SDC-1. xx .S19
BDE 400 MHz
Modem ProgTerm / DAC2K to BDE
Modem Modem_1. xx .S19
ADE 400 MHz
Modem ProgTerm / DAC2K to ADE
Modem Modem_1. xx .S19