Sea Tel DAC-2202, Installation And Operation Manual

Page: 92 / 115

Maintenance & Troubleshooting DAC-2202 Antenna Control Unit
8-6
8.7. Internal HTML Page
The following procedure(s) define the process of connecting and logging into the ACU’s internal HTML page with
COMMIF-1.10h software installed. **If the ACU’s IP address is unknown, use the “Configuring the COMM IF Module”
procedure to view or change connection settings, including but not limited to TCP Port assignment for existing LAN
firewall purposes.
1. Connect the “ETHERNET” port of
the rear panel of the ACU to a Local
Area Network (LAN) Connection or
directly to an available Ethernet
port on a Laptop/Desktop using a
standard CAT5 cable.
2. If not done so previously, apply
Power to the ACU.
3. Configure the connected LAN
connection with a static IP address
that is on the same sub net as the
ACU.
4. Start up your Internet Browser (i.e.
Internet Explorer, Mozilla Firefox,
etc.) and type in the IP address of
the ACU into the address bar.
5. Log into the ACU by typing in
Username and Password
information.
USERNAME: seatel
PASSWORD: 1234