Scout MT-700 ENT, Operation Manual

Page: 23 / 155

МТ-700 fleet tracking system 23
Figure 12

Prepare the SIM-card: make sure that all the needed packages are activated
(GPRS/HSDPA, SMS, voice calls, roaming, etc). Check the SIM’s balance. Turn off PIN
request if it is turned on.

Push the SIM-card extraction button to extract the SIM-tray.

Insert the SIM tray into the SIM-card aperture. Check if the tray has been fully
inserted; you should not be able to pull out the tray without pressing a button.
Figure 13. Terminal view from the connector jack

Preliminary tracker settings
You can configure the device using either local or remote “Configurator” or through SMS-
commands (see further in chapter 4).
To properly install the tracker you have to specify these settings :

GPRS settings:

login,

password,

access point.

Modem settings:

Phone number for SMS-commands.

Server connection:

IP-address,

Port.

Connection condition settings and port settings – depending on the required operational
mode and connected sensors and devices.
Terminals can be wirelessly configured and configured through SMS-commands. If the
modem correct GPRS, modem and server settings were not implemented during the mounting
process, then the remote configuration can only be accomplished through the SMS-commands.
The SCOUT employees’ phone numbers are embedded in the terminal’s white-list.
SIM extraction button
SIM-card tray