Scout MT-700 ENT, Operation Manual

Page: 25 / 155

МТ-700 fleet tracking system 25
Figure 14. Rubber burn mounting
Also, if the connectors’ lid is mounted, then the rubber burn should be installed under
the protective lid.
In order to achieve this, take the burn’s free tip and wrap the burn over the lid
(anticlockwise) ( Figure 15а ). Put the rest of the burn in the nearest cavity ( Figure 15
b
). Make sure
that the burn goes all around the enclosure.
A
b
Figure 15. Mounting the burn
If the tracker is installed with the connectors’ lid :

Use specified corrugated cable sleeve(10mm in diameter);

Install them in the grooves on the bottom lid ;

Pull the cable through the cable sleeve;

Tie the sleeves with zip ties ( Figure 16 );

Power on the device;
Bottom
lid
Start here
Burn’s
slot
The rest of the burn