Scout MT-700 ENT, Operation Manual

Page: 76 / 155

МТ-700 fleet tracking system 76
Figure 78. 1-Wire on the P3
The buzzer can be activated by setting the «indication port» in the 1-Wire settings ( Figure
78 ). The buzzer is connected to the specified port.
Once the ignition is on, the buzzer generates a signal once every 10 seconds and the
sensor signal: «Identification has not been made».
After the key has been attached, the buzzer stops the indication and the signal
«Successful identification» and driver ID is sent.
If the key code was not recognized, then the sensor will send the “Identification has
not been made” value and the buzzer indication will continue.
After the ignition is off, the sensor will send « Identification has not been made ».
When the ignition is off, the buzzer will stop the indication.
Outside relay control
– allows you to change the specified output state if successful
identification has occurred.
Inverting signal
– allows you to change the specified output state of the digital output if
the identification was NOT successful.
Reconcile the driver ID
– allows you to reconcile the identification with the white list,
written in the terminal.
«White list» button
– opens the white list dialogue ( Figure 79 ), which provides the
opportunity to administrate the white list.
«Copy to buffer» button
– is used to save the buffer of the captured ID.