Scout MT-700 ENT, Operation Manual

Page: 29 / 155

МТ-700 fleet tracking system 29
1.1.
Past the seal(26x60) on lid’s junction. The seal should be put on the top lid. Make
sure it does not cover the indication LEDs.
Figure 23
1.2.
Thread the spiral wire through the connectors’ lid ’s apertures and the loose ends
through the indicator seal and tighten them ( Figure 24 ).
Figure 24
1.3. Thread the spiral wire through the connectors’ lid ’s apertures and the loose ends
through the indicator seal and tighten them ( Figure 25 ).
Figure 25
1.4. Thread the spiral wire through the connectors’ lid ’s apertures and make an
additional rotation over the connectors’ lid , then put the loose ends through the indicator seal and
tighten them (
Figure 26 ).
Figure 26
1.5.
Connectors’ lid can be sealed in four different ways, but make sure that the lid
cannot be detached without damaging the seal.