МТ-700 fleet tracking system
67
Digital inputs P0-P5 setting
Digital inputs are intended to connect logic sensors, which operate in two different states
– on and off, which correspond accordingly to high and low voltage levels. Such sensors are:
“Ignition state”, “Panic button”, movement sensor and others.
Figure 63. Digital input parameters
Available sensors are: («Digital value», «Ignition», «Battery disconnect switch», «panic
button») they only differ by the icon picture in the PORTS tab. The settings are identical
Digital input has the following parameters:
Ports P0-P1:
Figure 64.
Ports P0-P5:
Debounce timeout (мс)
– minimal pulse length, which can be fixated. The parameter is
used to protect against false actuation.
Recommended value – 1000, for the panic button – 100.
Invert the signal
– Inverts the logic of work. By default, the High voltage on the input
corresponds to a value “1”. After inverting the “1” is corresponding to a low level of signal.
Ignition filtering–
if the parameter is on, all of the sensor’s changes are not counted until
the ignition is “ON”.
Summary of Contents for MT-700 ENT
