Scout MT-700 ENT, Operation Manual

Page: 26 / 155

МТ-700 fleet tracking system 26

Make sure that the terminal is working (based on the LED indication);

Assemble the lids together (make sure that both latches are in place);

If needed, screw the lids together.
Figure 16. Cable sleeves mounting
Install the tracker on the vehicle. The terminal should be anchored to stationary parts of the
vehicle. Also, the device should be mounted with the connectors facing down.
The operating position of the device is vertical, with the connector
facing down. If not properly mounted, then the ingress protection lowers
drastically.
The device should be attached to maximize the rigidity of the overall construction, there
should be no displacement or vibrancy of the terminal during the operation. You can use fix ties,
screws, bolts and sticky tape to fixate the terminal cable.
Recommended fixing options:
1. Bolts/screws.
1.1. Screw the terminal tightly on both sides using a screw or a bolt ( Figure 17 ). Make
sure that it is screwed tightly and does not dangle.
Figure 17
2. Sticky tape.
2.1. Stick the tracker using sticky tape onto the stationary car part. The tape should be
put on the bottom lid ( Figure 18 ).