Scout Boats 420 LXF, Owner'S Manual

Page: 72 / 202

72
Electrical System
Accessory Switch Panel In Garmin Display
CZone Display Monitoring Screen
Starting and stopping procedure
Make sure the engines are shutdown with the shift
levers in the neutral position and your hand is on
the control levers. Touch the panel with the elec-
tronic key fob to unlock and activate the panel. The
panel will beep twice to indicate it is unlocked and
the buttons are active. Once the panel is activated,
press the IGNITION button, then the START/STOP
button for the port engine. It is not necessary to
hold the button, just press it once and release it.
The computer will automatically check all engine
systems and start the engine. Once the engine
stabilizes, repeat the starting procedure for the
other engines. Stop the engines by pressing the
START/STOP buttons again. Touch the panel
with the electronic key to deactivate and lock the
panel. The panel will beep once to indicate that
it is locked and the engines and START/STOP but-
tons are deactivated.
6.6 12 volt Accessory Switch Panels
Digital Switch System
Your boat is equipped with a CZone digital switch-
ing system that provides reduced complexity and
increased switching options for the lights and
accessories the switches control. The system
consists of the CZone display screens, control
output modules, push button digital switch panels
and touch screen switches in the helm electronics
display panels.
Each circuit is protected by individual spade type
fuses located in a fuse panel built into each control
output module. The control output modules are
where the switching of input and output current
load to the selected accessories takes place. The
controllers in each module recognize low voltage,
digital signals from the switches and activate the
correct programed combination of circuits for each
switch function (i.e. the navigation lights switch
actually forces the forward navigation lights and
the anchor light to be turned on at the same time).
Interior or cockpit light switches may be pro-
gramed to activate different colors for multicolored
LED lights activated by the switches as well as
their ON or OFF status. All switches in the push
button switch panels are a “press to activate” and
“press to deactivate” design. LED lights in each
switch indicate the circuit is activated.
This section provides a general description of
the accessories typically activated by the CZone
switch panels. CZone switch programing is unique
to each boat, depending on optional equipment
installed at the factory or by your dealer and dis-
play preferences chosen at the time of delivery.
Consequently, switch programing on your boat
may be different.
Refer to the CZone Control System section in this
chapter and the Scout CZone operation manual
for additional information on the digital switching
system. Your dealer and or Scout representative
will also provide you with hands-on instructions
at the time of delivery.
https://www.boat-manuals.com/