User Manual SMO1000A-S
44/176
Run Control
Press the
Run/Stop
or
Single
button on the front panel to run or stop the sampling
system of the scope.
When the
Run/Stop
b is green, the oscilloscope is running, that is, acquiring data
when trigger conditions are met. To stop acquiring data, press the
Run/Stop
button.
When stopped, the last acquired waveform is displayed.
When the
Run/Stop
button is red, data acquisition is stopped. Red "Stop" is
displayed next to the trademark logo in the status line at the top of the display. To
start acquiring data, press
Run/Stop
.
To capture and display a single acquisition (whether the oscilloscope is running or
stopped), press
Single
. The
Single
run control lets you view single- shot events
without subsequent waveform data overwriting the display. Use
Single
when you
want maximum memory depth for pan and zoom.
When you press
Single
, the display is cleared, the trigger mode is temporarily set to
Normal (to keep the oscilloscope from auto- triggering immediately), the trigger circuitry is
armed, the
Single
key is illuminated, and the oscilloscope waits until a user defined
trigger condition occurs before it displays a waveform.
When the oscilloscope triggers, the single acquisition is displayed and the oscilloscope is
stopped (the
Run/Stop
button is illuminated in red).
Press
Single
again to acquire another waveform
Summary of Contents for SMO1000A-S
