Mounting and adjustments, size 10 - 14
50
12.00 | SRM | Assembly and Operating Manual | en | 1346850
Setting the center position - basic unit with center position
(Variant -M)
NOTE
The center position can be adjusted by ± 45°. When approaching
this position, over-swiveling and settling may occur.
1. Loosen nut (2).
2. Apply pressurized air to air connection "C".
✓
Pinion swivels to center position
3. Unscrew the stop spindle (4) slightly.
4. Turn pinion (1) clockwise to the stop and keep it pressed.
5. Turn stop spindle (3) and set the desired center position.
6. Screw in stop spindle (4) until the center position is free of play
again.
IMPORTANT! If the stop spindle is screwed in too far,
the play increases again.
7. Tighten nut (2).
✓
Tightening torque: 1.2 Nm
✓
Center position is set.
8. Swivel repeatedly to test the setting, readjust if necessary.
Summary of Contents for SRM 10
Page 135: ......
