Schmidt ACS 1200, Operation And Maintenance Manual

Page: 10 / 76

10 Copyright © 2020 Axxiom Manufacturing, Inc.
1.1.
GENERAL RULE FOR SAFER OPERATION.
SCHMIDT® ABRASIVE BLASTERS HAVE BEEN DESIGNED TO BE SAFE WHEN USED
IN THE PROPER MANNER. ALL ABRASIVE BLASTERS ARE POTENTIALLY
DANGEROUS IF ALL SAFETY PRECAUTIONS ARE NOT RIGOROUSLY FOLLOWED.
PROPER TRAINING IS REQUIRED BEFORE OPERATION. PROPER PROCEDURES MUST
BE FOLLOWED. THE ABRASIVE BLASTER AND ALL COMPONENTS MUST BE
PROPERLY MAINTAINED. FAILURE TO OPERATE, SERVICE AND MAINTAIN THE
ABRASIVE BLASTER AS SET FORTH IN THIS MANUAL MAY CAUSE INJURY OR EVEN
DEATH TO ANY PERSON USING, SERVICING OR IN THE VICINITY OF THE ABRASIVE
BLASTER.
THIS MANUAL IDENTIFIES POTENTIAL HAZARDS BY DANGER, WARNING, AND
CAUTION SYMBOLS. HOWEVER, ALL THE RULES, PROCEDURES AND
RECOMMENDATIONS MUST BE FOLLOWED. FAILURE TO OPERATE PROPERLY IS
VERY LIKELY TO PLACE PERSONS AND PROPERTY AT HIGH RISK OF DAMAGE,
INJURY OR EVEN DEATH.
ABRASIVE BLASTERS AND THE ABRASIVE BLAST OPERATION ARE POTENTIALLY
DANGEROUS IF ALL SAFETY PRECAUTIONS ARE NOT FOLLOWED. FAILURE TO
OPERATE THE ABRASIVE BLASTER WITHOUT FOLLOWING ALL THE
RULES FOR
SAFER OPERATION MAY RESULT IN SERIOUS INJURY OR DEATH TO OPERATING
PERSONNEL OR PERSONS IN THE OPERATING VICINITY.
1.2. KNOW YOUR EQUIPMENT.
Do Not operate this equipment in a manner other than its intended application (see Section 4.0). Do
Not operate this equipment or any other Schmidt® equipment without following the
Rules for Safer
Operation and all the operating procedures and instructions. Learn the applications and limitations
as well as the specific potential hazards related to this machine. Failure to do so could result in
serious injury or death.
1.3. RECEIVE PROPER TRAINING.
Do Not operate this equipment unless you have received operational and maintenance training.
Begin by thoroughly reading and understanding this operation and maintenance manual and all
included information. Consult an authorized Schmidt distributor or Axxiom manufacturing, Inc.
1.4. PROTECT YOUR FEET.
Do Not operate this equipment without wearing OSHA approved foot protection. Observe all
applicable local, state, and federal regulations. See Section 3.10 and OSHA 29 CFR 1910.136.
Heavy objects can shift while being blasted and may fall on operators. All operators and personnel
in the vicinity must wear OSHA approved foot protection during the operation of this equipment.
See Section 3.10 and OSHA 29 CFR 1910.136.
1.0 Rules for Safer Operation