4
Children and adults should be alerted to the hazards of high surface temperature and should stay
away to avoid burns or clothing ignition.
Instruct everyone in the house how to shut gas off to the insert and at the gas main shut off valve.
The gas main shut off valve is usually next to the gas meter or propane tank and requires a wrench to
shut off.
Start the insert using the built-in piezo igniter. Do not use matches or any other external device to light
your insert.
Never remove, replace, modify or substitute any part of the insert unless instructions are given in this
manual. A trained technician must do all other work. Do not modify or replace orifices
The pilot flame must contact the thermopile and thermocouple (see page 34) if it does not, turn on the
gas control valve to OFF and call your insert dealer.
Do not throw this manual away. This manual has important operating and maintenance instructions
that you will need at a later time. Always follow the instructions in this manual.
If the insert is equipped with optional blower, which requires 120-volt power, do not remove the
grounding prong from the plug. Do not route the electrical cord in front of, over, or under the insert.
Krog Iversen & CO grants no warranty, implied or stated, for the installation or maintenance of your
insert, and assumes no responsibility of any consequential damage(s). Please see page 54 Warranty
conditions.
The insert, when installed, must be electrically grounded in accordance with local codes or, in the ab-
sence of local codes, with the National Electrical code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1
Summary of Contents for 70 gas insert / ZC-fireplace
