SawStop TSA-FOT, Owner'S Manual

Page: 47 / 72

42
TSA-FOT OWNER’S MANUAL
WITHOUT WING
8
9
Install a tube end cap into the open ends of both table tubes attached to the
insert table (see Fig. 42 or the exploded view on page 57 for reference).
Slide the two rear rail clamps onto the rear rail of the table saw, and use a
5mm hex L-wrench to tighten the M10 x 20 set screws against the rear rail.
See Fig. 43.
Pivot the insert table and attached table tubes up until the top surfaces of the
insert table and table tubes are parallel with the top of the saw table.
Lay a straight-edge across one of the table tubes so that it extends over the
top of the saw table as well. The top surface of the table tube should be flush
or just beneath the top of the saw table. The height of the table tubes relative
to the saw table can be adjusted by changing the number of M6 washers
above and below the clamp mounting brackets.
If the table tube extends above the saw table, use a 5mm hex L-wrench and
a 10mm wrench to remove the M6 lock nut securing the clamp mounting
bracket to the table tube. Move one of the washers from above the clamp
mounting bracket to below the clamp mounting bracket, then replace the
original four washers below the clamp mounting bracket and M6 lock nut and
tighten the lock nut. Alternatively, if a table tube is too low relative to the saw
table, move one of the washers from below the clamp to above the clamp.
Requires:
Tube End Cap Pack (1) 10mm Wrench (1)
5mm Hex L-Wrench (1)
Fig. 42