SawStop TSA-FOT, Owner'S Manual

Page: 55 / 72

50
TSA-FOT OWNER’S MANUAL
WITHOUT WING
18
Position the set of table tubes with the small table roller at the right end of
the table support tubes. The rear rail clamp should be on the table tube
furthest from the insert table. If it is not, remove it and switch it to the table
tube furthest from the insert table.
Slide the rear rail clamp onto the rear rail of your table saw, but do not tighten
the set screw. Align the mounting holes in the table tubes with the mounting
holes at the left end of the table support tubes (marked as holes “Z” in
Fig. 48 on page 46), making sure that tube end caps are almost flush with
the rear rail. There are two sets of two holes paired together in the top and
bottom of each table tube; you will use the hole in each pair that is further
from the table saw (see Fig. 53).
Insert an M6 x 35 socket head cap screw through one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining three sets of mounting holes in the two
table tubes and table support tubes.
Fig. 53