SawStop TSA-FOT, Owner'S Manual

Page: 48 / 72

43
TSA-FOT OWNER’S MANUAL
WITHOUT WING
Recheck the alignment and move more washes as necessary. Then repeat
this adjustment for the clamp on the other side of the insert table. Recheck
both table tubes to make sure they are still correct.
Use a 5mm hex L-wrench to loosen the set screws and remove the rear rail
clamps from the rear rail.
Set the assembly aside.
Position the remaining rear rail clamp between the set of table tubes (A)
attached to a small table roller (E), so the rear rail clamp is between the table
tubes, the clamp mounting bracket extends under the right table tube (from
the perspective of the user of the table saw), and the open end of the clamp
extends away from the small table roller (see Fig. 44 for reference).
10
Fig. 43