SawStop TSA-FOT, Owner'S Manual

Page: 52 / 72

47
TSA-FOT OWNER’S MANUAL
WITHOUT WING
14
15
Locate the two support legs (C) and remove the two leveling feet from the
Support Leg Hardware Bag along with the two M8 hex nuts. Thread an M8
hex nut onto the threaded shaft of each foot so that the nut is close to the
rubber base, and then thread the foot into the bottom of a support leg (see
Fig. 49).
Place one support leg (C) between the two table support tubes (B), with the
open end of the support leg on the left and the leveling foot extending toward
the right (from the perspective of a user of the table saw).
Align the mounting hole in the top of the support leg (C) with the support leg
mounting hole in the table support tube (B) further from the table saw. Insert
an M8 x 70 button head socket screw through an M8 x 20 washer, then
through the exposed mounting holes in the table support tube, another
M8 x 20 washer, the exposed mounting holes in the support leg, another
M8 x 20 washer, and an M8 lock nut (see Fig. 50). Use a 5mm hex L-wrench
on the socket screw and a 13mm wrench on the nut to tighten the lock nut
until the support leg can pivot, but still moves with some resistance.
Repeat the process with the other support leg, but place the other support
leg on the other side of the table support tube (further from the table saw),
with the open end of the support leg on the right and the leveling foot
extending toward the left.
Requires:
Support Leg Hardware Pack (1) 13mm Wrench (1)
5mm Hex L-Wrench (1)
C
C
B
B
x2
C
Fig. 49
Fig. 50
You may need to pivot
the first support leg
partially out of the way
in order to install the
washer and lock nut for
the second support leg.
i