SawStop TSA-FOT, Owner'S Manual

Page: 13 / 72

8
TSA-FOT OWNER’S MANUAL
WITH WING
1
Begin by placing two table tubes (A) on a flat surface, such as a table, with
the four
larger table support tube mounting holes on the bottom , and the
roller mounting holes on the sides.
Insert an M6 x 45 socket head cap screw through an M6 x 16 washer, then
through the roller mounting holes in one of the table tubes (with the head
of the socket head cap screw on the side facing away from the other table
tube), then through two M6 x 10 washers, a ball bearing, and an M6 lock nut.
Use a 5mm hex L-wrench and a 10mm wrench to tighten the lock nut.
Repeat this process for the other table tube. You should now have two table
tubes with the larger table support tube mounting holes on the bottom, the
heads of the screws facing away from each other, and the ball bearings
between the table tubes (see Fig. 2 or the exploded view on page 57 for
reference).
Requires:
Table Roller Hardware Pack 5mm Hex L-Wrench (1)
Insert Table Hardware Pack 10mm Wrench (1)
Fig. 2
A