SawStop TSA-FOT, Owner'S Manual

Page: 26 / 72

21
TSA-FOT OWNER’S MANUAL
WITH WING
FOR OR SAWS ONLY:
Position the two table tubes (A) attached to
the insert table (D) across the four table support tubes (B), in the middle of
the overlapping sections of the table support tubes, with the insert table and
rear rail clamps on the end closest to the table saw.
Align the mounting holes in the table tubes with the two sets of aligned holes
in the center of the overlapping sections of the table support tubes (marked
as holes “W” in Figure 16 on page 20). Insert an M6 x 35 socket head cap
screw through one of the exposed mounting holes in one of the table tubes
and table support tubes. Secure the socket head cap screw with an M6 x 16
washer and an M6 lock nut. Do not tighten the lock nut at this time.
Repeat this process for the remaining seven table support tube mounting
holes in the table tubes attached to the insert table. Refer to Fig. 17 below.
When finished, skip ahead to page 24.
Requires:
Table Tube Hardware Pack 10mm Wrench (1)
5mm Hex L-Wrench (1)
It is very important to use the correct mounting holes in the table support tubes. Check
carefully to make sure the insert table and attached table tubes are aligned correctly.
There should be one set of aligned holes and five non-aligned holes to the left of the
table tubes, two non-aligned holes between the table tubes, and one set of aligned
holes and five non-aligned holes to the right of the table tubes.
i
Fig. 17