SawStop TSA-FOT, Owner'S Manual

Page: 29 / 72

24
TSA-FOT OWNER’S MANUAL
Requires:
Support Leg Hardware Pack (1) 13mm Wrench (1)
5mm Hex L-Wrench (1)
WITH WING
Locate the two support legs (C) and remove the two leveling feet from the
Support Leg Hardware Bag along with the two M8 hex nuts. Thread an M8
hex nut onto the threaded shaft of each foot so that the nut is close to the
rubber base, and then thread the foot into the bottom of a support leg (see
Fig. 21).
Place one support leg (C) between the two sets of table support tubes
(B), with the open end of the support leg on the left and the leveling foot
extending toward the right (from the perspective of a user of the table saw).
Align the mounting hole in the top of the support leg (C) with the support
leg mounting hole in the table support tube (B). Insert an M8 x 70 button
head socket screw through an M8 x 20 washer, then through the exposed
mounting holes in the support leg, another M8 x 20 washer, the exposed
mounting holes in the table support tube, another M8 x 20 washer, and an
M8 lock nut (see Fig. 22).
13
14
B
B
B
B
C
C
x2
C
Fig. 22
Fig. 21