SawStop TSA-FOT, Owner'S Manual

Page: 54 / 72

49
TSA-FOT OWNER’S MANUAL
WITHOUT WING
17
Position a solitary table tube (A) (not attached to a table roller) across the two
table support tubes (B), with the clamp mounting holes on the end closest to
the table saw. Align the mounting holes in the table tube with holes labeled
as “Y” in Fig. 48 on page 46.
Position the other solitary table tube (A) on the other side of the insert table
(D), and align the mounting holes in the table tube with the holes marked as
holes “Y” in Fig. 48 on page 46.
Insert an M6 x 35 socket head cap screw through one of the exposed
mounting holes in a table tube and table support tube, then through an
M6 x 16 washer and an M6 lock nut. Do not tighten the nut at this time.
Repeat this process for the remaining three sets of mounting holes in the two
solitary table tubes and table support tubes. Refer to Fig. 52 below.
A
A
Fig. 52