SawStop TSA-FOT, Owner'S Manual

Page: 53 / 72

48
TSA-FOT OWNER’S MANUAL
WITHOUT WING
16
Slide the rear rail clamps attached to the table tubes with the insert table
onto the rear rail of your table saw, keeping the insert table between the
miter gauge slots in your saw table. Use a 5mm hex L-wrench to thread the
set screws into the clamps enough so they engage the rear rail, but do not
tighten them. They need to remain loose so you can align the outfeed table
to the table saw.
Pivot the support legs down so the leveling feet contact the ground.
Fig. 51