SawStop TSA-FOT, Owner'S Manual

Page: 40 / 72

35
TSA-FOT OWNER’S MANUAL
WITHOUT WING
2
3
Press a table roller bushing into each end of the large table roller (F), then
press the other side of one of the table roller bushings onto one of the ball
bearings you just attached to a table tube. Do not attach the large table roller
to the other ball bearing yet.
Place the insert table (D) between the table tubes (A), with the text on the
bottom so the three mounting holes in the side of the insert table line up with
the three insert table mounting holes in the table tube attached to the large
table roller (see Fig. 35).
Be careful when positioning the insert table because it is not yet secured
to the tubes and could fall or scratch the table tubes. Insert an M6 x 40
socket head cap screw through an M6 x 16 washer, then through one of the
exposed mounting holes in the table tube and insert table, and secure it with
a second M6 x 16 washer and an M6 lock nut. Use a 5mm hex L-wrench and
a 10mm wrench to tighten the lock nut.
Repeat this process for the other two exposed mounting holes in the table
tube attached to the large table roller and the insert table.
A
F
F
Table Roller
Bushing
F
D
A
Fig. 34
Fig. 35