SawStop JSS-120A60, Owner'S Manual, Page: 67 / 100

You must remove the riving knife
before cutting the zero-clearance slot .
4
1
2
3
1A
1B
The blade slot in original insert is pre-cut at
factory. However, you must cut a slot in any
replacement inserts.
Rotate the clamp handle (1A), and then
remove riving knife/blade guard (1B). Lower
blade fully and adjust tilt angle to zero
degrees.
Install new table insert. Adjust leveling screws
until table insert is level and slightly below
table (
see page 54 ).
Clamp a thick piece of wood across right side
of table insert to securely hold table insert to
table.
Start motor and slowly raise blade ( see page
38 ) to its highest elevation. This will create
the slot for cuts at zero degrees tilt.
CUT SLOT IN ZERO-CLEARANCE INSERT
SawStop ® Jobsite Saw Pro
|
67