SawStop JSS-120A60, Owner'S Manual, Page: 46 / 100

Bypass Mode On . Saw is in Bypass Mode.
Paddle Out . Start/Stop paddle is out. Push in
to clear.
Bypass Mode Activated . Red light flashes
once, indicating Bypass Mode has activated
(
see page 50 ).
Blade Contact While Stopped . Contact
detected while blade was stopped. Wait 5
seconds for red status light to turn off.
Blade Contact During Bypass . Contact
detected while saw is in Bypass Mode. Will
clear when blade stops.
Brake Key Error . Turn power switch off and
reinstall brake key.
Overload Due to Moisture .
Material is too
wet or green. Cycle power to clear. Allow
material to dry or cut in Bypass Mode.
Small or Missing Blade . Switch power off,
unplug the power cord and install 10” blade
(or 8” Dado set and brake).
Blade Stalled . Cycle power and cut material
more slowly. Call SawStop Technical Support
if issue persists (
see page 6 ).
Replace Cartridge . Cycle power. If error
does not clear, replace brake.
46
|
SawStop ® Jobsite Saw Pro