SawStop JSS-120A60, Owner'S Manual, Page: 56 / 100

3
4
1
2
3A
3B
Insert 3 mm hex key wrench (3A) at an angle
into hole in left side of fence head. Rotate
screw (3B) clockwise to shift fence left, or
counter-clockwise to shift fence right. Lock
fence and check alignment. Make further
adjustments as necessary. When fence is
parallel to the miter slot, tighten screw in top
left side of fence head. (Reverse Step 2)
Once fence alignment is done, lock and
unlock fence to make sure it is still tightly
secured to rail. If fence slides while locked,
or feels loose, use a 3 mm hex key wrench to
tighten screw on front of fence.
Raise blade fully. Make sure the table is fully
retracted. Move fence so its left side rests
against right side of blade. If indicator lens
reads 0” (0 mm) on ruler, no adjustment is
needed. If indicator does not read 0” (0 mm)
proceed to next step.
Use a 3 mm hex key wrench to loosen bolt
next to indicator lens.
Adjust Indicator Lens
56
|
SawStop ® Jobsite Saw Pro