Sanyo PLC-XM100, Owner'S Manual

Page: 57 / 149

57
3
Note:
• Factory default is Ready: 5 Min .
• When the shutter is closed while the Power management function
is working, the Power management function is released.
Setting
Select a location of the infrared remote receiver of the remote control.
See “Remote Control Receivers and Operating Range” on page 15 for
details.
All ............ Activate all of the receivers.
Front & Top . . . . . .Activate both the front and top receivers.
Top & Back . . . . . . Activate both the top and back receivers.
Front & Back . . . .Activate both the front and back receivers.
Front ....... Activate only the front receiver.
Top .......... Activate only the top receiver
Back ........ Activate only the back receiver.
Timer left before Lamp is off.
Power management
Min
For reducing power consumption as well as maintaining the lamp life,
the Power management function turns off the projection lamp when
the projector is not operated for a certain period.
Select one of the following options:
Ready .................. When the lamp has been fully cooled down, the
POWER indicator changes to green blinking. In
this condition, the projection lamp will be turned
on if the input signal is reconnected or any
button on the side control or remote control is
pressed.
Shut down ........... When the lamp has been fully cooled down, the
power will be turned off.
Off ........................ Power management function is off.
Timer .................... If the input signal is interrupted and no button
is pressed for more than 30 seconds, the timer
display with
No signal appears. It starts the
countdown until the lamp is turned off. Use the
Point
Ÿź buttons to set the Timer(1~30Min).
This function is available when operating the projector via network.
Network .......... Supply the power to the network function
even after turning off the projector. You can turn
on/off the projector via network, modify network
environment, and receive an e-mail about projector
status while the projector is powered off.
Eco .................... Select Eco when you do not use the projector
via network. The projector’s network function will
stop when turning off the projector.
Refer to the owner’s manual of “Network Set-up and Operation”.
3
Note:
• Factory default is Network .
• When selecting Network , the cooling fans may be running depending
on the temperature inside the projector even if the projector is turned
off.
RC sensor
Power management
Standby mode