Barco FL40 projector quick guide
Turning on
Press buttons (P1) or (R1) indicated in images above. The projectors power button will start blinking
blue light. The power on sequence might take a minute or two. When the light is constantly showing
blue, the projector is on.
IF THE PROJECTOR POWER WAS COMPLETELY OFF (ELECTRIC CORD NOT CONNECTED), READ THE
MANUAL SECTION 5.2.
Turning off
Press buttons (P1) or the “O” button right next to (R1) indicated in images above. Keep the button
pressed for approximately 4 or 5 seconds. During this time in the LCD screen of the projector a
power-down image is shown indicating the time how long to continue pressing the button should be
still continued. When the projector is powered down and cooling down, the light on the power
button (P1) will first blink white and then turn constantly white.
IF IT IS NECESSARY TO REMOVE THE POWER CORD OF THE PROJECTOR FOR SOME REASON
(NORMALLY THIS IS NOT AT ALL NECESSARY), DO NOT REMOVE THE POWER CORD OR TURN OFF
ELECTRICITY BEFORE THE PROJECTOR HAS BEEN POWERED DOWN FOR A COUPLE OF MINUTES!!
P1
