− 58 −
No.
Item
Setting range
/
Edit unit
Initial value
Compensation of back tack return at sewing end
Compensation value of back tack return at sewing end is set.
* It is possible to set only when
is set to selection of back tack.
* It is possible to set only when
compensates with pattern data.
–2.0 to 2.0
/
0.1mm
1.0mm
※
Stacking position
After moving clamp foot as far as the set distance from the position of cor-
ner knife, stacker is actuated. (+ : rear side, - : front side)
* Range of actuating amount is limited by the position of clamp foot at the
time of sewing end.
* Use
clamp bar stacker or
roller stacker. In addition, it is
possible to set only when
roller stacker motion setting or
clamp bar stacker motion setting is performed.
0 to 500mm
/
1mm
0mm
※
Stacker timer 1
Roller rotation time is set. When material sensor has detected without ma
-
terial before setting time, rotation stops.
*
roller stacker option is used and it is possible to set only when
roller stacker motion is set.
0.0 to 9.9
/
0.1 sec.
0.5 sec.
※
Jump feed speed up to the position of sewing start
Jump feed speed up to the position of sewing start is set.
3 to 8
/
1
5
Jump feed speed up to the position of corner knife
Jump feed speed up to the position of corner knife is set.
3 to 6
/
1
5
Dart stretcher device stop/motion change-over
Stop/motion of dart stretcher device is selected.
* It is possible to set only when
dart stretcher option is used.
- - -
※
Stop
Motion
Automatic interlining supplying device stop/motion change-over
Stop/motion of automatic interlining supplying device is selected.
* It is possible to set only when
automatic interlining supplying
option is used.
* Regarding the interlining supplying, when the pattern is not used, be
careful not to make the interlining come out from the top surface of the
table. When using next, press once the feeding button on the panel and
perform the feeding motion to cut.
- - -
※
Stop
Motion
※
. . . Item that is not displayed due to other setting state