![background image](http://html2.mh-extra.com/html/sandisk/apw-895n-ip-420/apw-895n-ip-420_instruction-manual_4643768010.webp)
− 6 −
5. CONNECTING THE POWER PLUG
Connection of the power plug to the power depends on the specifications of the product. Adjust the power
plug to the power specifications to connect.
①
In case of the product of single-phase, 220 to 240V specifications :
Connect the sky-blue and brown wires of the power cord to the power terminal (AC220 to 240V) and the
yellow/green wire to the ground (earth) terminal respectively.
②
In case of the product of 3-phase, 200 to 240V specifications :
Connect the red, white and black wires of the power cord to the power terminal (AC200 to 240V) and
the yellow/green wire to the ground (earth) terminal respectively.
③
In case of the product with the optional high voltage transformer (with SA-128) :
Connect the black wires (3 pieces) of the power cord to the power terminal (AC380 to 415V) and the
yellow/green wire to the ground (earth) terminal respectively.
It is possible to connect to 380/400/415V by setting of the input tap of transformer (standard setting at
the time of delivery : 380V).
CAUTION
:
To prevent possible accidents caused by leakage or dielectric strength, an appropriate power plug
shall be installed by a person who has an expert knowledge of electricity. Be sure to connect the pow
-
er plug to the receptacle that is well grounded.
This product performs operation by the single-phase connection for 3-phasse 380/400/415V.
[ Caution when changing the power source of the high voltage optional transformer ]
When using high voltage optional transformer
❶
with
the input voltage of 400V or 415V, it is necessary to
replace input power source cord
❷
of high voltage
optional transformer
❶
. Change power source input
cord
❷
(sky blue) that is connected to 380V to the
connection of 400V or 415V.
To prevent accidents, perform the work
after leaving the sewing machine alone
more than 4 minutes in the state that
the power switch is turned OFF and the
power cord is drawn out.
High voltage optional transformer
❶
is set on the
rear side of the table.
When performing changeover of voltage, remove
transformer box
❹
after removing top cover
❸
.
❸
❹
❶
❷