V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230247
V21
General Information | G-3
INITIAL SET-UP
A.
UNPACKING
Remove all plastic film, cardboard and tape from the outside of the vendor. Loosen any
shipping devices used to secure interior parts during shipment (backspacer, shims or
spacers).
To remove shipping boards from base, raise vendor on a well-stabilized lifting device.
Remove the leveling bolts which hold the boards in place and remove the boards. Replace
bolts to equal heights in the threaded holes. Another method to remove shipping boards is
to split the boards apart. Using a pinch bar or a heavy screwdriver and hammer, insert tool
into the slots and force the boards apart.
The leveling legs shall not raise the vendor
more than 1 1/8 inch above the ground.
B.
POSITIONING
IMPORTANT: PLACE THE VENDOR IN DESIRED LOCATION AT LEAST THREE TO FOUR
INCHES (7.6CM TO 10.2CM) AWAY FROM ANY REAR OBSTRUCTION.
This
is for proper
air flow through the refrigeration compartment. The refrigeration system
requires rear to
front air circulation for proper operation.
C.
POWER SUPPLY CONNECTION
CAUTION:
DO NOT USE AN EXTENSION CORD!
The vendor’s power requirements will vary depending upon the country it was purchased for. To
verify the power requirements of the vendor, check the serial plate located on the hinged side of
the outer door (see Figure 4 on page G-4). The power requirements are listed on the serial plate.
To ensure safe operation of the vendor, the vendor’s power supply must be a properly
grounded and polarized outlet. Before plugging the vendor into the outlet, test the outlet to
confirm it will meet the vendor’s power requirements. If the power supply of the outlet is
different from the power requirements of the vendor, a transformer may be necessary.
If the power requirements are not properly met, contact a licensed electrician and have the
necessary correction made.
Should you require additional information, contact the Technical Services Department of the
SandenVendo America, Inc. office in your area.
