V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230247
V21
General Information | G-12
VEND MECHANISM PARTS DESCRIPTION
The parts listed below are part of the vend motor mechanism (refer to Figure 7 on page G-10).
One mechanism is required per column, except the drop sensor assembly, which is one
assembly per machine. The parts are interchangeable. Setting will differ between single, double,
triple, and quadruple depth.
VEND MOTOR ASSEMBLY:
The motor is attached to the mech plate by two screws.
VEND BUCKET:
The vend bucket holds the product(s) in a “ready to vend” position at the base of each column.
MOTOR COUPLING CAM:
The coupling cam couples the motor to the bucket. It is located behind the motor, on the motor
shaft. It is also a means to provide feedback to the controller to determine when the motor has
reached maximum clockwise and counterclockwise positions.
GATE:
The gate holds product above the vend bucket.
GATE LINK:
The rotation of the coupling cam moves the gate link. This opens the gate, allowing one layer of
product to drop into the bucket.
CAN STEP (NOT APPLICABLE ON 521 MODELS):
The can step is located at the bottom of the stack partition. It is pulled forward when vending
cans and is moved back for bottle vending.
REAR BUSHING:
The rear bushing provides a low friction pivot for the rear of the bucket.
FRONT SPACER:
The front spacer helps to guide product into the bucket.
DROP SENSOR ASSEMBLY:
The drop sensor assembly is located below the delivery chute. When a product is vended, the
drop sensor senses the impact, and cancels the credit.
FRONT BUSHING (ONLY APPLICABLE ON 521 MODELS):
The front Bushing provides a low friction pivot for the front of the bucket.
