V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230298
SET-UP AND CODE DESCRIPTION
Eror
Error Display Mode
If selection button two is pressed at the “
Eror
” prompt, the controller will enter the Error
Display Mode. If no errors have occurred, the display will show “
nonE
”. If an error has been
detected since the last error reset, the display will show the first error summary code that has
occurred. If selection button three is pressed while displaying any summary code, the controller
will return to the “
Eror
” prompt.
Note:
See the Trouble Shooting section for errors and how to clear them.
EXAMPLE:
“
CJO1
”
would indicate a column jam error in column 1.
COIn
Coin Pay Out/Tube Fill Mode
If selection button two is pressed at the “
COIn
” prompt, the controller will enter the Coin Pay
Out Mode. Pressing selection one will scroll through the denominations and pressing selection
button two will start the denomination flashing. The display will indicate the denomination
along with the number of that coin stored in the coin mechanism. If selection button two is
pressed, a pay out of the displayed value will be made. Coins will continue to pay out as long as
that selection button is held down.
EXAMPLE:
If selection button two is pressed while 5 cents is displayed it will pay out a nickel.
When the controller enters the
“
COIn
”
mode, the operator is allowed to deposit any coin into the
coin changer’s acceptor when that coin’s tube is not full. The tube inventory level will be displayed
after each coin is accepted.
tESt
Test Mode
If selection button two is pressed at the “
tESt
” prompt, the controller will enter the Test Mode
where you are able to test the motors, the display, the compressor, the lights, the evaporator
fans and the heater.
UEnd
Vend Testing
Pressing selection button two at the test mode will enter the controller into the vend test mode.
Upon entry into the vend test mode the display will show the first summary test, “
COL1
”
(column 1). Pressing selection button one will scroll through the column selections. Pressing
selection button two will test vend the displayed column. In order to exit the setting, press
selection button three.
V21
12.1 Programming Trade | P3-4
