Sanden Vendo Vue SXY 30, Manual

Page: 42 / 128

P-10
Part #1167879 08/2008
4. To Exit, press and hold Button 1 for 5 seconds or until Display returns to ‘Test
Mode Switches’
Test Mode Relays:
This Mode allows you to test the following relays:
1. Compressor
2. Fluorescent Light
3. Heater
4. Fan
1. Press Button 2 to scroll until “Relays” is displayed.
2. Enter on Button 4.
3. Enter on Button 4 – Compressor ‘Off’
4. Enter again on Button 4 – ‘Off’ flashes
5. Advance on Button 2 – ‘On’ flashes
6. Enter on Button 4 – Compressor should turn ‘on’ if relay is functional
7. Exit on Button 1 – Compressor will default back to ‘Off’
Repeat steps 1 through 5 for desired relay. To exit ‘Test Mode’ and return to the Main Menu,
press Button 1 three times.
Calibration:
Calibration PDC Software Maintenance:
The PDC Maintenance Position Mode should only be accessed if a chip needs to be replaced in
the Hand. Please refer to the ‘Trouble Shooting Section’ of the SXY Manual.
1. Press Button 2 to scroll until “Calibration” is displayed.
2. Press Button 4 to Enter.
3. Enter on Button 4 – Maintenance ‘Off’
4. Press Button 4 – ‘Off’ flashes
5. Advance on Button 2 – ‘On’ flashes
6. Save on Button 4 – Hand should extend for access to the Control Board
*** After completion of work in ‘Calibration PDC Software Maintenance’, ensure that X,
Y, Z and Clamp Motors have returned to the ‘Home’ position - Power down vendor, wait 1
minute then Power on vendor BEFORE closing the outer door. It will perform a Recovery/
Discovery automatically. ***
Calibration Discovery:
Please refer to the Levels and explanations listed below:
Level – 0 We are not doing a ‘Discovery – no motion. No Discovery is required
Level – 1 Check Physical Shelves against the stored data. If shelf is in stored data,
is there a reflector that corresponds to it
Level – 2 Sets vendor for actual physical locations for trays and shelves