Sanden Vendo Vue SXY 30, Manual

Page: 107 / 128

M-2
Part #1167879 07/2008
MAINTENANCE
The following section is a basic guide for general maintenance and servicing of the
vendor. This section is divided into three parts: (I) Preventative Maintenance, (II)
Lubrication Guide, and (III) Care and Cleaning.
I. PREVENTATIVE MAINTENANCE SUGGESTIONS:
Whenever a vendor is visited on its site, the following service should be performed.
Preventative maintenance will help prevent future problems with the vendor.
A. Observe the vendor and its surrounding area for any unusual indications of
problems (rear of cabinet, obstructions of the air flow, condensate puddles,
lamp off, etc.).
B. Open the door and visually check the inside of the vendor (water accumulation,
rust marks, moisture around the edges of the door, etc.).
C. Check the fluorescent lamp, replace as necessary. Replace lamp within 24
to 48 hours of burnout. This will prevent damage to the ballast. *
D. Check the product temperature for proper cooling.
E. Check the evaporator drain for obstruction; water in the evaporator area must
drain to the condensation pan.
F. Clean the condenser fins.
G. Check that evaporator fan runs normally.
H. Check that the compressor and condenser fan run normally.
I. Investigate any unusual sounds (fan blades hitting something, refrigeration
lines rattling, etc.).
J. Clean coin acceptor.
K. Check for proper operation of the coinage mechanism by inserting all
denominations of coins accepted by the vendor.
L. Test the vendor and make a report on the problems.
*
NOTE: The VUE vendor features a circuit interrupting style ballast. If the lamp is
replaced, you must cycle the power to the machine to bring the light back on.
II. LUBRICATION GUIDE:
Lubricate indicated areas as directed on the chart below.
INTERVALS PARTS LUBRICANT
Every six months Door latch slide mechanism & T-handle
assembly Grade two, high low temperature grease