Samsung SHR-4040P, User Manual

Page: 25 / 75

If you move to the block as you wish and hit the ( ) key during motion detection area
allocation, you may select or unselect the whole area.
indicates an area has been selected.
If you want to select or unselect 4 areas to be selected simultaneously one by one, you shall
presss the 1 , 2 , 3 , and 4 key. is used to select the 4 areas at once.
Upon setup, press the button to display the following menu.
5
Alarm Output / Buzzer Setup
4-8
Here comes the setup status of ALARM Output/Buzzer menu.
① ALARM OUT DURATION
Displays the alarm duration period.
[3 sec/5 sec/10 sec/20 sec/30 sec/1 min/2 min/3 min/5 min/10 min]
➁ ALARM OUT (Alarm output Setup for each channel)
Sets up ALARM OUT of the channel which received alarm signal.
[OFF/1/2/ALL]
➂ M.D ALARM OUT
Determines ALARM OUT upon detecting any movement.
[OFF/ON]
➃
VIDEO LOSS BUZZER
Determines whether the buzzer sounds when no video signal comes in from the
camera which was turned on during channel setup. Depending on it is set to ON or
OFF, the buzzer will 3-16 sound or not.
[OFF/ON]
➄ ALARM BUZZER
Upon receiving ALARM, it determines whether the buzzer sounds or not.
Depending on it is set to ON or OFF, the buzzer will sound or not.
[ON/OFF]
➅ M.D BUZZER
Upon detecting movement, it determines whether the buzzer sounds or not.
Depending on it is set to ON or OFF, the buzzer will sound or not.
[ON/OFF]
DIGITAL IMAGE RECORDER
4
Alarm Input/Motion Detection Setup
4-7
Here comes the initial setup status of the ALARM RECORD SETUP menu.
①
ALARM IN
It is set to OFF during no alarm input.
It is set to N.C.(Normally Close) and N.O.(Normally Open) when the alarm input is
Active High and Active Low respectively. [N.C/N.O/OFF]
➁ M.D. SENS.
It sets up the sensitivity of motion detection for motion detection setup.
There 3 setup stages, Low, Medium, and High. High and Low indicates high sensi tivity and
low sensitivity of motion detection respectively while Medium indicates normal sensitivity.
OFF indicates motion detection has been suspended. [OFF/LOW/MEDIUM/HIGH]
➂ M.D AREA
It allocates a motion detection area to each channel.
If you press , the motion detection area allocation screen will pop up as follows.
MENU
➛
➛
➛
You can save the setup value or select/unselect the whole area in the menu.
EXIT WITH SAVE
EXIT WITHOUT SAVE
SELECT ALL BLOCKS
CLEAR ALL BLOCKS
ALARM IN/MOTION DETECTION SETUP
CH A-IN M.D.SENS. M.D.AREA
1 OFF LOW [...]
2 N.O MEDIUM [...]
3 N.C HIGH [...]
4 OFF OFF [...]
œ❷➛❿
:MOVE :SELECT MENU:EXIT
ALARM OUT/BUZZER SETUP
ALARM OUT DURATION 3 SEC
CH1 ALARM OUT 1
CH2 ALARM OUT 1
CH3 ALARM OUT 2
CH4 ALARM OUT ALL
M.D.ALARM OUT ON
VIDEO LOSS BUZZER ON
ALARM BUZZER ON
M.D. BUZZER ON
œ❷ :MOVE :SELECT MENU:EXIT
SHR-4040P/ENG-1 7/24/03 10:28 AM Page 4-7