Samsung SHR-4040P, User Manual

Page: 11 / 75

1-12
DIGITAL IMAGE RECORDER
1-11
4.Pull the BRACKET-HDD toward the product center and detach the fixing part at the
bottom to detach the BRACKET-HDD.
6. Fix the HDD installed BRACKET-HDD to the detached part again..
(Assembling will be done in the reverse manner of disassembling. Align the 5 fixing holes at
the bottom of the HDD with those of the BRACKET-HDD and push it out ward the product
until screw fixing holes are aligned. Then tighten screws firmly.)
7. Check if the BRACKET-HDD has been fixed in the product rigidly and connect the
power supply cable and signal transmission cable (IDE CABLE) to the HDD.
8. Check if all connectors and cables are in good condition then close the cover.
9. Tighten cover fixing screws. (5 points on both sides and 1 point in the back)
✻
You can install 2 HDDS to a BRACKET-HDD as shown in the figure.
5.Tighten a SCREW-SPECIAL(BWH,6-32UNC,L10.5) which was supplied as an
accessory at 4 points to fix the HDD to the BRACKET-HDD. (The screw shall be
tightened enough not to be loosened by vibration.)
SHR-4040P/ENG-1 7/24/03 10:27 AM Page 1-11