installation & connection
16_
installation & connection
connecting the audio/alarm cable and power cable
1.
Remove the dome cover and the case.
2.
Pull out the rubber plug on the bottom as shown in the figure.
3.
Insert the alarm/audio cable through the hole created by removing the
rubber cap in No. 2, and connect the cable to the alarm terminal.
4.
Align the cable so that it should not be damaged or jammed when
installing the camera.
5.
Put the rubber cap located on the alarm/audio cable in the hole.
6.
Insert the power cable into the small-sized hole through the long, carved
groove.
7.
Connect the power cable to the power terminal block.
8.
Adjust the lens in a desired direction by referring to the “
adjusting the
monitoring direction for the camera
” section. (page 17)
9.
Attach the dome cover.
RESET
NETW
ORK
ACT
LINK
RESET
NETW
ORK
ACT
LINK
CAUTION: Be ware
of the
Rated Voltage and
Polarity
of the power conn
ection.
RESET
NETW
ORK
ACT
LINK
attaching to the unbundled adapter
Choose and purchase a necessary one of the following options (unbundled) that is suitable to the installation
site or for your convenience.
1.
Remove the dome cover from the case by referring to the “
Disassembling
” section. (page 15)
2.
Use the provided machine screw to fix the camera case to the unbundled adapter.
3.
Connect and arrange the necessary cables lest that they should be damaged or twisted while installing the
camera.
4.
Install the camera body in the reverse order of “
Disassembling
”.
5.
Adjust the lens in a desired direction by referring to the “
adjusting the monitoring direction for the
camera
” section. (page 17)
6.
Close the dome cover.
`
Securely fasten the fastening bolt using an L wrench to prevent water from leaking.
outdoor installation
When you install it outside of the building, please waterproof it with waterproof butyl rubber tape (can be
purchased in stores) so that water does not leak from the gap of the cable connected to the outside.
1.
Connect the power, I/O, BNC, and LAN cables.
2.
Wrap the black cable jacket (Area A) and the cable connection area
with waterproof (butyl rubber) tape so that more than half of the
butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause
leakage. Make sure to protect the cable with a dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to twice
its normal length.
Camera
Camera
Camera
System
System
System
A
A
