294 • Integrated Payment Appendix
Sam4s SPS-300 OP Manual v1.35
Dial In Load/Dial Out Load
For Legacy DataTran equipment
:
If instructed by Datacap support, you can use these options to update DataTran software.
Choose Enable Dial In Load to allow Datacap to call the DataTran and send updates. Choose
Enable Dial Out Load to call Datacap to connect. You will be required to enter the phone
number and terminal I.D. (password) which will be given to you by Datacap.
For TwinTran
:
When a TwinTran is first installed, the dealer
must do a Dial Out Load through the IP
connection
. If, for any reason, the internet is not available, the device cannot be loaded. If it is
being installed at a location where the Internet is not currently operational and the customer
wants to use the dial out method for approvals, the procedure below must be done at a location
where the internet is working.
To load a TwinTran using a Sam4s register:
With the TwinTran connected to the register and an active Ethernet line, enter into the Dial Out
mode. At the Phone number field enter the number “1”. If the register uses the code entry
method for alpha characters enter the 3-digit code (049). At the Enter ID prompt, enter the serial
number of the TwinTran. Select Tone phone connection. The TwinTran will call Datacap’s host
PC and load itself. This takes approximately 20 seconds. After the TwinTran is loaded, one
successful credit transaction must be done. After that the unit can be connected as the customer
wishes.
For EMV (Chip Card Capable)
Refer to the separate SPS-300 EMV Supplement available on the CRS Web Site:
https://www.crs-usa.com/
Tip Operation
Follow the prompts to enter the record number, original transaction amount and tip amount. If
the record number and transaction number are valid, the tip amount is entered in the batch and a
tip entry chit prints.
