Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
60
selects AC (j=0) or DC (j=1).
ILIND(?)i{,j}
The ILIND command sets and queries the notch filter status. The parameter i represents
the selected channel (A or B). The parameter j indicates the notch filter status. The
parameter j selects to close notch filters (j=0), open the 50Hz notch filter (j=1), open the
50Hz and 100Hz notch filter at the same time (I=2) or open the 100Hz notch filter (j=3).
4.2.4 Sensitivity and Time Constants Commands
SENSD(?)i{,j}
The SENSD command sets or queries the sensitivity. The parameter i represents the
selected channel (A or B). The parameter j indicates the sensitivity. The parameter i is
used to select a different range.
j sensitivity
j sensitivity
0: 1 nV/fA
14: 50 uV/pA
1: 2 nV/fA
15: 100 uV/pA
2: 5 nV/fA
16: 200 uV/pA
3: 10 nV/fA
17: 500 uV/pA
4: 20 nV/fA
18: 1 mV/nA
5: 50 nV/fA
19: 2 mV/nA
6: 100 nV/fA
20: 5 mV/nA
7: 200 nV/fA
21: 10 mV/nA
8: 500 nV/fA
22: 20 mV/nA
9: 1 uV/pA
23: 50 mV/nA
10: 2 uV/pA
24: 100 mV/nA
11: 5 uV/pA
25: 200 mV/nA
12: 10 uV/pA
26: 500 mV/nA
13: 20 uV/pA
27: 1 V/uA
RMODD(?)i{,j}
The RMODD command sets or queries the mode of dynamic reserve. The parameter i
represents the selected channel (A or B). The parameter j indicates the mode of dynamic
reserve. The parameter i selects <Low Noise> (j=0), <Normal> (j=1) or <High Reserve>
(j=2).
OFLTD(?)i{,j}
The OFLTD command sets or queries the time constant of filters. The parameter i
represents the selected channel (A or B). The parameter j indicates the time constant of
filters. The parameter i selects a time constant below.
i time constant
i time constant
1: 10 us
10: 300 ms
2: 30 us
11: 1 s
3: 100 us
12: 3 s
