![Saluki SE1022D User Manual Download Page 58](http://html1.mh-extra.com/html/saluki/se1022d/se1022d_user-manual_3698021058.webp)
Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
58
SVSLD(?)i {,x}
The SVSLD command sets or queries <Step> amplitude in <Linear> <Sine Output> sweep
mode. The parameter i represents the selected channel (A or B). The parameter x indicates
the step amplitude (unit:V).The SVSLD? 1 command will return the step amplitude of
linear sweeping amplitude mode of channel A. The range of x is 0.000 Vrms≤x≤5.000Vrms
and the minimum resolution is 0.001Vrms.
SVSGD(?)i {,x}
The SVSGD command sets or queries the percentage in <Log> <Sine Output> sweep
mode. The parameter i represents the selected channel (A or B). The parameter x indicates
the percentage (unit:%).The SVSGD? 1command will return the percentage in <Log>
sweep amplitude mode of channel A. The range of x is 0-100 and the minimum resolution
is 0.001. x=50 means that the percentage is 50%.
SVTMD(?)i {,x}
The SVTMD command sets or queries step <Time> in <Sine Output> sweep mode. The
parameter i represents the selected channel (A or B). The parameter x indicates the step time
(unit:ms).The SVTMD? 1 command will return the step <Time> of logarithm amplitude
sweeping of channel A. The range of x is 1ms-100,000ms and the minimum resolution is
1ms.
SVRMD(?)i {,j}
The SVRMD command sets and queries the executing mode in <Sine Output> sweep
mode. The parameter i represents the selected channel (A or B). The parameter j indicates
the selected mode. The parameter i selects <Stop> (j=0), <Single> (j=1) or <Loop> (j=2).
4.2.2 Equation Commands
EQCDD(?)i,j{,k,l,m} The EQCDD command sets or queries the ’R’ value of A, B and C in four <Equation>.
Parameter i and j are necessary for transmitting this command. The parameter i represents
the selected channel (A or B). The parameter j indicates the selected equation. The
parameter i selects Equation1(j=1), Equation2(j=2), Equation3(j=3) or Equation4(j=4).
The parameter k, l, m are corresponding to A, B, C in <Equation> and selects the
numbers below.
k, l,m
Parameter
0
R
1
X
2
Y
3
θ
4
Rh1
5
Xh1
6
Yh1
7
θh1
8
Rh2
9
Xh2
10
Yh2
11
θh2