Sakai SW884, Operator'S Manual

Page: 57 / 127

2 OPERATION
– 52 – – 53 –
Emergency traveling
If the machine doesn’t move when you operate the forward and reverse control lever while
the engine is running, there may be a problem with the control system.
In this case, you may bypass the controller to temporarily drive the machine by following the
procedure below.
1) Push on the Parking brake switch. Shut off the engine and make sure the Emergency
propel switch is in the neutral position.
2) Identify the connectors PRO & EME on the SCR cover on right side of the machine.
3) Remove the plugs from connector PRO then exchange connectors PRO and EME.
4) Make sure the connectors are properly connected, close the hood but do not start the
engine until you have checked the surrounding area for obstacles.
Also make sure that the Emergency propel switch and traveling direction of the machine
are the same. Now it will be safe to move the machine to a safe area.
Fuel pre-filter
Right side of machine
[EME] Connector
[PRO] Connector
SCR cover
|
Parking brake switch
Emergency propel switch