The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide
•
Rev. 1.3
•
© SAF Tehnika JSC 2010
61
14.
Port 2 LAN
–
STP parameters of LAN 2 port;
15.
Port 4 LAN
–
STP parameters of LAN 4 port;
16.
Port 5 WAN
–
STP parameters of WAN port;
17.
State
–
port condition. Can be one of the following:
Disabled
,
Blocking
,
Listening
,
Learning
,
Forwarding
or
Broken
;
18.
Priority (0..65535)
–
Port Priority. Combination of Priority, Port number and
Path Cost determines whether the port will be selected as Root port or will be
blocked on the occasion of loop, etc;
19.
Path cost selection
–
path cost for WAN port can be set manually (default) or
calculated automatically with “byACM” option enabled, which operates
according to ACM swiching;
20.
Path cost
– this parameter setting depends on the capacity of a separate
port;
setting is disabled when automatic “Path cost selection” is enabled;
21.
Path cost mode
- automatic Path Cost mode of WAN port. Can be Short or
Long;
22.
Path cost offset -
offset of the WAN port automatic Path Cost;
23.
Pressing “Execute configuration” applies changes made to the corresponding
section only for the local side CFIP Lumina
. If “Rollback on” is selected,
configuration will be reverted in case of erroneous configuration changes
applied;
24. Writes to configuration file all the changes made on the whole page
(command line
–
cfg write
);
25.
FODU returned -
in case of error or incorrectly entered parameter value, or
other problems on the whole page
– the info message is being shown here.
Otherwise it says “Ok”.
4.7.2 Spanning Tree Status
Spanning tree status shows current STP status at all available ports. Description of
parameters is in Chapter 4.7.1. Besides information about currently elected Root port is being
shown.
