The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide
•
Rev. 1.3
•
© SAF Tehnika JSC 2010
48
2.
TFTP service
–
starts TFTP service for file transfer between both CFIP
Lumina link sides. By default TFTP service is not running (command line
–
net start tftp
).
4.3.3 Static Route Configuration
1.
Static routes
–
shows the list of existing static routes, as well as allows you to
choose specific route you are willing to change or delete. By default there is
one route which depends on earlier entered IP settings (command line
–
net
route
);
2.
Network address
–
allows specifying network address for the route
changing/adding (command line
–
net route add|delete
<dest addr> [MASK
<mask>] <gateway>
);
3.
Network mask
- allows specifying network mask for changing/adding the
route (command line
–
net route add|delete
<dest addr> [MASK <mask>]
<gateway>
);
4.
Gateway
- allows specifying gateway for the route changing/adding
(command line
–
net route add|delete
<dest addr> [MASK <mask>]
<gateway>
);
5. After entering addresses or selecting a
specific route, buttons “Add”,
“Change” and “Delete” allow you to modify CFIP Lumina routes. If “Rollback
on” is selected, configuration will be reverted in case of erroneous
configuration changes applied.
6. Writes to configuration file all the changes made on the whole page
(command line
–
cfg write
);
7.
FODU returned -
in case of error or incorrectly entered parameter value, or
other problems on the whole page
– the info message is being shown here.
Otherwise it says “Ok”.
(!)
Do not make any changes to default route; otherwise, management connection to CFIP will be lost.
