5.2.7.3 Smear the seal around the cap with grease.
Ensure that the cap (37) is installed in position as
shown (see arrow). Otherwise, in the case of a
flanged brake chamber, the cap (37) can no longer
be used (see Fig.).
Note: The cap (37) should be replaced even if the
brake pads are not replaced.
5.2.8 If the clearance is smaller than 0.6 mm,
the following parameters and functions must be
checked:
5.2.8.1 Check the function of the brake chamber in
accordance with the information from the manufac-
turer.
5.2.8.2 Check the end position of the lever spheri-
cal bearing in the brake.
5.2.8.3 Remove the brake pads (see item 6.1). Re-
move any dirt from the pads, calliper and carrier.
Check the brake pads for incorporation of the
pressure fittings, replace the brake pads if
necessary.
Check the contact surfaces in the carrier for
incorporation, replace the carrier if necessary.
5.2.8.4 Check the brake disc. For brake discs from
SAF-HOLLAND (see 5.1). For brake discs from
other manufacturers, observe their information.
5.2.8.5 Check the movement of the brake calliper
over the entire movement path (see 5.3).
5.2.8.6 Install the brake pads (see 6.2).
5.2.8.7 Mount the brake chamber (see 12.2
or 12.4).
5.2.8.8 Double check the adjustment function
(see 5.2.6ff).
If the clearance at both pressure fittings is still
smaller than 0.6 mm, the brake calliper must be
replaced.
5.2.9 Fit the wheels (observe the information
from the respective vehicle manufacturer).
5.2.7.3 - Seal around cap and installation position
Function and visual inspection
18
en
XL-SA40001RM-en-DE Rev A • 02.2016 • Errors and changes excluded © SAF-HOLLAND
