DT Etherlink IV
User Manual
- 61 -
CO_FMM>
The command displays the name of the difference parameter and data from two configurations. In
the above example one can see that the VLANMASK parameter of interface 3 (WAN2) of the VLAN
group in the running configuration differs from the backup configuration. If there are no differences,
the result is presented as follows:
CO_FMM>DIFF N R
------------------------------------------------------------------------
New configuration Running configuration
------------------------------------------------------------------------
--- No differences --- --- No differences ---
------------------------------------------------------------------------
CO_FMM>
4.6.4.18 <DUMP N/R/S/B> Command
This command displays the dump of the corresponding configuration: New. Running, Startup or
Backup.
CO_FMM>DUMP R
------------------------------------------------------------------------
Dump of running configuration
------------------------------------------------------------------------
NET.MAC_ADDRESS
00 0F D9 00 10 03
M.DEVICE_ID
00 00 00 00 00 00 00 00 00 43 4F 4D 4D 4F 4E 00\
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00\
00
NET.MAC_SPEED
5A
SNMP.TRAPIP.0
00 00 00 00
SNMP.TRAPIP.1
00 00 00 00
SNMP.COMMUNITY
43 4F 4D 4D 4F 4E 00 20 60 00 00 13 00 02 B2 3C\
00 18 65 44 00 05 5E 2C FF FF FF FF 00 17 59 F8\
00
M.ALARM_CUTOFF
02
NET.IP
C0 A8 5A 14
NET.NETMASK
FF FF FF 00
NET.GATEWAY
C0 A8 5A 64
NET.PPPREMIP
C0 A8 5A 5A
PE1.G704.0
01
SE1.G704.1
01
PE1.CRC4DET.0
00
SE1.CRC4DET.1
00
...
------------------------------------------------------------------------
CO_FMM>
The results of the command show the coded configuration of the device and can be copied from the
terminal window into the notepad as well as saved on any data carrier. This txt file can be
downloaded into a similar device with the help of the LOAD command via the XModem or 1K
XModem protocols.
4.6.4.19 <LOAD> Command
The <LOAD> command downloads the configuration file obtained with the help of the DUMP
command into a device via the XModem or 1K XModem protocols. For Windows 95 or above, this
