DT Etherlink IV
User Manual
- 74 -
ALL means a local loop forced by line 141 is allowed. Data from line 103 is looped to line 104
and clock from line113 is looped to line 115 (use in TTC clocking mode)
DATA means local loop forced by line 141 is allowed. Data from line 103 is looped to line 104.
4.6.5.37 <EXTCLOCK [SRC] [DIR]> Command
This command defines the Nx64 clocking modes.
SRC:
NORMAL means clocked by DSL
INT means clocked by internal oscillator
TTC means clocked (Received Clock) by line 113 (Terminal Transmit Clock)
DIR:
CO means Codirectional mode
CONTRA means Contradirectional mode
CO_01_CM>EXTCLOCK INT CO
4.6.5.38 <NET> Command
The <NET> command allows to enter into the submenu for NET settings.
4.6.5.39 <H> Command
Type <H> and the monitor lists all available commands in the NET sub-menu. If you type H
[command] you will get additional help on [command].
CP_NET>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
APPLY [ALL/GROUP] Apply changes to running configuration
LINK [NN] Establish local connection
LINKCLEAR Exit all local connections
NETCONFIG Show network configuration
NETCONFIG [N/R/S/B] Show new/running/startup/backup network configuration
RSTP DEFAULT Show RSTP state/configuration
RSTP [CONF/STATE] Show RSTP state/configuration
RSTP [BR/IF] [OPT] [N] Set RSTP Bridge/Interface properties
RSTP [A..E] [ON/OFF] Switch RSTP ON/OFF at PBVLAN A..E
PBVLAN [IF] [A..E] Set port-based VLAN for the interface
MODE [IF] [ACC/TRUNK/MIX]Set mode of LANx interfaces: access, trunk, mixed
VLAN [IF] [1..8] Set default VLAN index for access ports
QOS [IF] [0..7] Set default QoS for access ports
ALLOW [IF] [VLAN list] Set list of VLANS to allow on trunk interface
VID [1-8] ID Assign VID to the VLAN specified
SETIP x.x.x.x Set modem IP address
GATEWAY x.x.x.x Set gateway IP address
NETMASK x.x.x.x Set netmask
ETHSD [MODE] [N=1-5] Set Nth Ethernet port speed
TRAPIP [ADD/DEL] x.x.x.x Set/delete IP address for SNMP trap messages
COMMUNITY Set SNMP community name
SNMPSET [ON/OFF] Enable/disable SNMP SET commands.
NETDEFAULT Set default network configuration
CONNECT [N:[1-13/R]] Establish connection to remote unit
M Return to Configuration Management Menu
H Show available commands
-------------------------------------------------------------------------------
CP_NET>
4.6.5.40 <NETCONFIG [N/R/S/B]> Command
Without parameters the <NETCONFIG> command displays the running configuration of the network
subsystem and interfaces:
CO_NET>NETCONFIG
--------------------------------------------------------------------------------
Running Network Configuration
